Does the Little Dot MkII drive the Koss Porta Pro?

Computed from measured specifications · target SPL 110 dB · load 32 Ω

Verdict

Ample

The Little Dot MkII drives the Koss Porta Pro with ample headroom (~15.6 dB headroom at 32 ohms; needs ~2.8 mW, delivers 100 mW). Note: output impedance for this amp isn't reliably published, so the damping interaction into this 72 Ω load can't be assessed; treat low-impedance pairings with caution.

Headroom
15.6 dB
Required (110 dB SPL)
2.8 mW
Delivered (@ 32 Ω)
100 mW
Required voltage
0.45 Vrms

Power Headroom

Headroom: 15.6 dB 0 · target 15.6 dB below target marginal adequate ample -14 dB +10 +20 +36 dB

Scale shows dB headroom above the 2.8 mW required to reach 110 dB SPL. Amp delivers 100 mW at 32 Ω (+15.6 dB above target).

Koss Porta Pro Dynamic · on-ear
Impedance (rated) 60 Ω
Impedance (measured) Source: reference-audio-analyzer.pro/en/r… 72.15 Ω measured
Sensitivity (rated) 101.0 dB/mW
Sensitivity (measured) 105.6 dB/mW measured
Driver Dynamic
Spec basis Measured
Measured by Reference Audio Analyzer (https://reference-audio-analyzer.pro/en/report/hp/koss-porta-pro.php) · Source ↗
Little Dot MkII Desktop Tube · Single Ended
Output impedance assumed Not published
Power @ 32 Ω 100 mW
Power @ 120 Ω 200 mW
Power @ 300 Ω 300 mW
Power @ 600 Ω 150 mW *est.
Power source Manufacturer low confidence
* Loads marked "est." are derived from the published voltage ceiling at a lower-impedance load (V = √(P·R) → P_higher = V²/R_higher). All derivations are upward only.
Little Dot MkII SEPP OTL circuit. Power figures (100/200/300 mW at 32/120/300 Ω) appear consistently across retailer listings (Linsoul, ShenZhenAudio) citing manufacturer spec. Note unusual characteristic: more power into 300 Ω than 32 Ω — typical for OTL amps. Output impedance not published; SEPP OTL topology suggests ~20–50 Ω but no reputable non-forum measurement found. Set null; damping check flagged as indeterminate. 600 Ω derived from 300 Ω. · Source ↗
Impedance — unknown output impedance

This amp's output impedance is not reliably published, so the damping interaction into this 72 Ω headphone cannot be assessed. Treat low-impedance pairings (below ~80 Ω) with caution.

Specification confidence: low

One or more amp specifications (power output or output impedance) are estimated rather than published by the manufacturer. Treat this pairing's verdict as approximate.

Where to buy

Disclosure: links above are Amazon affiliate links. As an Amazon Associate this site earns from qualifying purchases — at no extra cost to you. Affiliate commissions do not influence verdicts; all analysis is computed independently from the data.

AmplifierHeadroom
Schiit Lyr 3 Ample 33.4 dB
JDS Labs Atom Amp 2 Ample 29.8 dB
Topping DX3 Pro+ Ample 28.2 dB
Schiit Magni Heretic Ample 27.6 dB
Schiit Fulla 4 Ample 17.4 dB
Apple USB-C to 3.5mm Ample 10.5 dB
HeadphoneHeadroom
Sennheiser HD 660S Ample 18.2 dB
Sennheiser HD 560S Ample 16.7 dB
Sennheiser HD 599 Ample 10.9 dB
Audio-Technica ATH-M50x Ample 10.3 dB
AKG K240 Studio Marginal 1.0 dB
Fostex T50RP Mk3 Insufficient -0.9 dB