Does the Little Dot MkII drive the Sennheiser HD 560S?

Computed from measured specifications · target SPL 110 dB · load 120 Ω

Ample

The Little Dot MkII drives the Sennheiser HD 560S with ample headroom (~16.7 dB headroom at 120 ohms; needs ~4.3 mW, delivers 200 mW). Note: output impedance for this amp isn't reliably published, so the damping interaction into this 162 Ω load can't be assessed; treat low-impedance pairings with caution.

Headroom
16.7 dB
Required (110 dB SPL)
4.3 mW
Delivered (@ 120 Ω)
200 mW
Required voltage
0.83 Vrms

Power Headroom

Headroom: 16.7 dB 0 · target 16.7 dB below target marginal adequate ample -14 dB +10 +20 +36 dB

Scale shows dB headroom above the 4.3 mW required to reach 110 dB SPL. Amp delivers 200 mW at 120 Ω (+16.7 dB above target).

Sennheiser HD 560S Dynamic · over-ear
Impedance (rated) 120 Ω
Impedance (measured) Source: reference-audio-analyzer.pro/en/r… 161.7 Ω measured
Sensitivity (rated) 110.0 dB/mW
Sensitivity (measured) 103.7 dB/mW measured
Driver Dynamic
Spec basis Measured
Measured by Reference Audio Analyzer (https://reference-audio-analyzer.pro/en/report/hp/sennheiser-hd-560s.php) · Source ↗
Little Dot MkII Desktop Tube · Single Ended
Output impedance assumed Not published
Power @ 32 Ω 100 mW
Power @ 120 Ω 200 mW
Power @ 300 Ω 300 mW
Power @ 600 Ω 150 mW *est.
Power source Manufacturer low confidence
* Loads marked "est." are derived from the published voltage ceiling at a lower-impedance load (V = √(P·R) → P_higher = V²/R_higher). All derivations are upward only.
Little Dot MkII SEPP OTL circuit. Power figures (100/200/300 mW at 32/120/300 Ω) appear consistently across retailer listings (Linsoul, ShenZhenAudio) citing manufacturer spec. Note unusual characteristic: more power into 300 Ω than 32 Ω — typical for OTL amps. Output impedance not published; SEPP OTL topology suggests ~20–50 Ω but no reputable non-forum measurement found. Set null; damping check flagged as indeterminate. 600 Ω derived from 300 Ω. · Source ↗
Impedance — unknown output impedance

This amp's output impedance is not reliably published, so the damping interaction into this 161 Ω headphone cannot be assessed. Treat low-impedance pairings (below ~80 Ω) with caution.

Specification confidence: low

One or more amp specifications (power output or output impedance) are estimated rather than published by the manufacturer. Treat this pairing's verdict as approximate.

Where to buy

Little Dot MkII on Amazon ↗ Sennheiser HD 560S on Amazon ↗

Disclosure: links above are Amazon affiliate links. As an Amazon Associate this site earns from qualifying purchases — at no extra cost to you. Affiliate commissions do not influence verdicts; all analysis is computed independently from the data.

AmplifierHeadroom
Schiit Lyr 3 Ample 31.5 dB
Schiit Asgard 3 Ample 27.7 dB
Schiit Magni Heretic Ample 25.7 dB
FiiO K7 Ample 24.6 dB
Schiit Fulla 4 Ample 15.5 dB
Apple USB-C to 3.5mm Adequate 8.6 dB

See all amplifiers for the Sennheiser HD 560S →

HeadphoneHeadroom
Sennheiser HD 660S Ample 18.2 dB
Sony MDR-7506 Ample 16.6 dB
Sennheiser HD 599 Ample 10.9 dB
Audio-Technica ATH-M50x Ample 10.3 dB
AKG K240 Studio Marginal 1.0 dB
Fostex T50RP Mk3 Insufficient -0.9 dB

See all headphones for the Little Dot MkII →