Does the iFi Zen DAC V2 drive the Sennheiser HD 560S?

Computed from measured specifications · target SPL 110 dB · load 32 Ω

Ample

The iFi Zen DAC V2 drives the Sennheiser HD 560S with ample headroom (~18.2 dB headroom at 32 ohms; needs ~4.3 mW, delivers 280 mW). Note: output impedance for this amp isn't reliably published, so the damping interaction into this 162 Ω load can't be assessed; treat low-impedance pairings with caution.

Headroom
18.2 dB
Required (110 dB SPL)
4.3 mW
Delivered (@ 32 Ω)
280 mW
Required voltage
0.83 Vrms

Power Headroom

Headroom: 18.2 dB 0 · target 18.2 dB below target marginal adequate ample -14 dB +10 +20 +36 dB

Scale shows dB headroom above the 4.3 mW required to reach 110 dB SPL. Amp delivers 280 mW at 32 Ω (+18.2 dB above target).

Sennheiser HD 560S Dynamic · over-ear
Impedance (rated) 120 Ω
Impedance (measured) Source: reference-audio-analyzer.pro/en/r… 161.7 Ω measured
Sensitivity (rated) 110.0 dB/mW
Sensitivity (measured) 103.7 dB/mW measured
Driver Dynamic
Spec basis Measured
Measured by Reference Audio Analyzer (https://reference-audio-analyzer.pro/en/report/hp/sennheiser-hd-560s.php) · Source ↗
iFi Zen DAC V2 Dac Amp · Single Ended
Output impedance assumed Not published
Power @ 32 Ω 280 mW
Power @ 300 Ω 36 mW
Power @ 600 Ω 18 mW *est.
Power source Manufacturer low confidence
* Loads marked "est." are derived from the published voltage ceiling at a lower-impedance load (V = √(P·R) → P_higher = V²/R_higher). All derivations are upward only.
iFi Zen DAC V2 SE output: 280 mW @ 32 Ω, 36 mW @ 300 Ω (iFi tech lowdown PDF and product page). Output impedance: conflicting sources (manufacturer PDF cites '≤100 Ω unbalanced' which may refer to RCA pre-out, not the headphone jack; likely <<1 Ω for headphone output but unconfirmed). Set null; damping check flagged as indeterminate. 600 Ω derived from 300 Ω. · Source ↗
Impedance — unknown output impedance

This amp's output impedance is not reliably published, so the damping interaction into this 161 Ω headphone cannot be assessed. Treat low-impedance pairings (below ~80 Ω) with caution.

Specification confidence: low

One or more amp specifications (power output or output impedance) are estimated rather than published by the manufacturer. Treat this pairing's verdict as approximate.

Where to buy

iFi Zen DAC V2 on Amazon ↗ Sennheiser HD 560S on Amazon ↗

Disclosure: links above are Amazon affiliate links. As an Amazon Associate this site earns from qualifying purchases — at no extra cost to you. Affiliate commissions do not influence verdicts; all analysis is computed independently from the data.

AmplifierHeadroom
Schiit Lyr 3 Ample 31.5 dB
Schiit Asgard 3 Ample 27.7 dB
Schiit Magni Heretic Ample 25.7 dB
FiiO K7 Ample 24.6 dB
Schiit Fulla 4 Ample 15.5 dB
Apple USB-C to 3.5mm Adequate 8.6 dB

See all amplifiers for the Sennheiser HD 560S →

HeadphoneHeadroom
Koss Porta Pro Ample 20.1 dB
Grado SR80x Ample 19.8 dB
Sennheiser HD 660S Adequate 9.0 dB
AKG K702 Adequate 8.8 dB
Beyerdynamic DT 770 Pro 250 Marginal 0.0 dB
Beyerdynamic DT 990 Pro Insufficient -1.1 dB

See all headphones for the iFi Zen DAC V2 →