Does the Bottlehead Crack 1.1 drive the AKG K712 Pro?
Computed from rated specifications · target SPL 110 dB · load 300 Ω
Verdict
AdequateThe Bottlehead Crack 1.1 adequately drives the AKG K712 Pro with limited margin (~8.1 dB headroom at 300 ohms; needs ~51.1 mW, delivers 333 mW). Note: this OTL tube amp's high output impedance (120 Ω) interacts strongly with this low-impedance (62 Ω) headphone, which can audibly alter its tonal balance. OTL tube amps are best paired with high-impedance (250 Ω+) headphones; this is a less ideal match.
8.1 dB
51.1 mW
333 mW
1.78 Vrms
| Impedance | 62.0 Ω rated |
| Sensitivity | 92.92 dB/mW rated |
| Driver | Dynamic |
| Spec basis | Rated |
| Output impedance manufacturer | 120.0 Ω |
| Power @ 300 Ω | 333 mW |
| Power @ 600 Ω | 166 mW *est. |
| Power source | Manufacturer |
This OTL tube amp's output impedance (120 Ω) is high relative to this headphone's 62 Ω impedance (ratio 0.5×). OTL tube amps are best paired with headphones ≥ 250 Ω; this combination may cause audible tonal coloration.
Where to buy
Disclosure: links above are Amazon affiliate links. As an Amazon Associate this site earns from qualifying purchases — at no extra cost to you. Affiliate commissions do not influence verdicts; all analysis is computed independently from the data.
Other amplifiers for the AKG K712 Pro
| Amplifier | Headroom |
|---|---|
| Schiit Lyr 3 | Ample 20.7 dB |
| JDS Labs Atom Amp 2 | Ample 17.2 dB |
| Topping DX3 Pro+ | Ample 15.5 dB |
| Schiit Magni Heretic | Ample 15.0 dB |
| Little Dot MkII | Marginal 2.9 dB |
| Apple USB-C to 3.5mm | Insufficient -2.2 dB |
Other headphones the Bottlehead Crack 1.1 can drive
| Headphone | Headroom |
|---|---|
| Koss Porta Pro | Ample 20.8 dB |
| Grado SR80x | Ample 20.5 dB |
| Focal Clear (original) | Ample 15.3 dB |
| Audio-Technica ATH-AD700X | Ample 15.2 dB |
| AKG K240 Studio | Adequate 6.2 dB |
| Fostex T50RP Mk3 | Adequate 4.3 dB |